
					Firmware for 5010-AVS
				          Audio/Video Sync+


This release contains System Firmware version 1.1.0 and Boot file version 2.0a

See Manual for full information on installing this firmware update.


After installation, verify that the status menu in Dashboard indicates:
Software version - 1.1.0
Boot version - 2.0a



Changes for version 1.1.0 (Sept 21, 2014)

   Firmware changes to support Dashboard 6.



Changes for version 1.0.9 (Jan 21, 2014)

   Fixed possible issue with very infrequent picture and audio errors caused by false DCM resets.

   

Changes for version 1.0.8 (Nov 12, 2013)

   Added RGB Color correction and RGB,YCbCr Legalizer functions.

   Changed ProcAmp descriptions to better reflect terms used in the industry.
	Luma Offset (was Setup)
	Luma Gain (was Video Level)
	Chroma Gain (was Chroma)



Changes for version 1.0.7 (Nov 03, 2013)

   Fixed issues with STILL management using SD/MMC cards:
	Dashboard version 4 and 5 did not refresh selections when card inserted or ejected.
	STILLs did not save or load correctly on smaller SD cards where cluster size = 1 sector (i.e.32MB).
	STILLs did not Delete correctly if the file was segmented on the SD card.

   Added noise filtering for system controls.



Changes for version 1.0.6 (March 18, 2012)

   Added support for Micron Rev G SDRAM



Changes for version 1.0.4 (March 18, 2011)

   Added "Admin" tab in Dashboard control, with new feature to allow the card to be renamed.

   Added support for passing HANC Timecode in HD.

   Fixed bug in memory controller which allowed bad video to over-write Still#1 buffer.

   Improved auto-freeze function.



Changes for version 1.0.3 (March 11, 2011)

   Added support for passing Dolby-E signals.
	Fixed round-off error in audio gain control at 0.0dB setting which prevented Dolby-E from passing. 
	Fixed swapped channels in AES inputs when selecting AES input mode "Locked to Genlock"

	The 5010-AVS now detects non-PCM audio and automatically bypasses phase and gain settings.
	Detection method is based on SMPTE-337 Annex-B.

	Embedded output AES channel status now indicates non-PCM audio when signal detected.






(c)2014 by Calfiornia Media Engineering Inc.

